|
|
|
|
|
Message Forums |
 |
|
|
You are not authorized to post a reply. |
|
| Author |
Messages |
hyperpede
Posts:2
|
| Posted:10/13/2006 10:43:33 PM |
|
I've recieve my Stampede aluminium tranny case from RC-Monster and build it last night.
After put all the gear in it, i'll try to spin the spur gear but the gear don't want to make a full turn. It have a very tight "hard spot" in it.
So i re-open it and take the gear apart to inspect it, and to make a test, i replace the gear in the stock plastic case, and all spin freely in the stock case. (forget to say that i've the aluminium idler gear)
So i try to re-install the gear in the FLM case, but nothing to do, just don't want to turn.
I've try 2 other aluminium idler gear to see if it's my aluminium idler gear who's the problem and all other one did the same thing.
Change top shaft gear, same thing, hard spot still remaining.
So with 2 different top shaft, 3 different aluminium idler and the stock or steel diff gear, nothing spin freely.
Disapoint for the $70.00US that i've paid.....
|
|
chopndroptx
Posts:15
|
| Posted:4/18/2007 10:33:32 PM |
|
| You have to make sure the pins/shafts go all the way into the holes. By shafts I mean the shafts that go thru the gears. I had to tap mine in with a hammer, tight fit. Try checking that out, you should be ok.
|
|
|
|
You are not authorized to post a reply. |
|
ActiveForums 2.2
|
|
|
|
|
Banners |
|
|
|
|
|
|
|
|
|
|
|
|
|