|
|
|
|
|
Message Forums |
 |
|
|
You are not authorized to post a reply. |
|
| Author |
Messages |
warrior370
Posts:4
|
| Posted:1/26/2006 3:39:37 PM |
|
hi i brough a lcg extended tvp and i want to know about servo plating.
i know the servo plating offer lightweight than stock battery box but where put your receiver.....with no fuel tank modification.
thanks alot
if possible to put some picture of servo plating and servo receiver install.
Eric
|
|
admin
Posts:226
|
| Posted:1/30/2006 11:36:49 AM |
|
We mounted our electronics with servo tape. But there is a few different things you could do.
There is a picture under the F.A.Q. section that will show some of what you want.
|
|
shumzz
Posts:16
|
| Posted:1/30/2006 10:19:25 PM |
|
This will work for you.
Part number 80055 RPM Receiver Box
If you’re going to leave the fuel tank in stock position then this means you will be using the holes in the FLM servo plate to hold your servos. Put the box in the front of the plate and your battery pack next to the transmission. You will need to drill some holes in the plate and use zip ties to hold things down.
Shawn AKA Shumzz |
|
|
|
You are not authorized to post a reply. |
|
ActiveForums 2.2
|
|
|
|
|
Banners |
|
|
|
|
|
|
|
|
|
|
|
|
|