|
|
|
|
|
Message Forums |
 |
|
|
You are not authorized to post a reply. |
|
| Author |
Messages |
slawdog
Posts:15
|
| Posted:9/27/2005 9:46:39 PM |
|
hello
well got my axels squared away. had to have my Arms milled down alittle and it looks great. now to the drive shafts i have the hybird bulks with hyper7 diffs has anyone found drive shafts to work with this. the steal shafts i had which was from dynomite 21 converion will not work the orfice in the drive cup is to small and it hardend steal and a drill bit will not touch them. jamie do you make these drive cups or have a solition for this problem. i seen that the 21 chassie kit you offer has a dogbone and cup end with it but i only seen one and it looked like it was for the rear didnt see one for front please let me know thanks.
|
|
admin
Posts:226
|
| Posted:9/28/2005 4:29:12 PM |
|
What the problem is: the pin on the most dog bones measure .125". But the drive cup on your buggy diff measures approx. .123". They were designed for a pin diameter of 3mm (.118").
You can easily fix this by grinding on the OD of the pin. This works well.
Or you can order that shaft from us to fit the buggy diff. Let us know which ones are needed (front or rear). The cost for each shaft is $8.00.
We need to get some part #'s for these shafts, we will try to get them on the site ASAP.
|
|
slawdog
Posts:15
|
| Posted:9/28/2005 7:55:28 PM |
|
ok im not sure if you under stood what i was saying. i was trying to use 2.5driveshafts and the holes in the cups that came with the driveshafts is smaller than the hyper 7 pinion shaft. i was going to try and bore the holes in the 2.5 steal driveshafts to slip over the hyper 7 pinion shaft.
but it is harden steal and i cant do it at home it would have to done with a boring bar in a shop.
now this is the ? if i get hyper 7 drive cups for the driveshafts for the the diff (wich i didnt get when i bought the hyper 7 diffs ) do you have dogbones that will work with this for front and back. if so i wouldnt have to worrie about getting the others bored to fit the hyper7 pinion shaft. which would be easier
|
|
|
|
You are not authorized to post a reply. |
|
ActiveForums 2.2
|
|
|
|
|
Banners |
|
|
|
|
|
|
|
|
|
|
|
|
|